Aastra IP Phone Guide de l'utilisateur Page 32

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 125
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 31
6/1553-DBC 444 01 Uen A1 2010-06-10 32
S
TARTING, LOGGING ON AND OFF
5 Starting, Logging On and Off
This chapter describes how to start the phone, and how to log on and off.
It also describes free seating, and how to check which software version
is used.
All system settings for your phone must be set by the system adminis-
trator before you can use the phone.
Note: Depending on the settings in your network and telephony system,
the startup procedure in your phone may differ from the one
described in this manual. Check the display on your phone and
read the applicable sections.
5.1 Starting and Logging On
To start the phone, connect the required cables, see figure 11 on page
22. When the phone is connected to the network, the startup procedure
starts automatically.
5.1.1 Logging On To the Network
If LAN access control is displayed when you start the phone, you need
to log on to the network before logging on to the telephony system.
To log on to the network, do the following:
1. Enter the user ID and navigate to the password field.
2. Enter your password and press Log on.
Note: If you do not know your user ID or your password, contact
the system administrator.
3. The phone receives the network settings.
If the user ID or password is not accepted, the following message
is displayed: “Failed Authentication! Check User ID/Password!”.
Then press Retry and make a new logon attempt.
Note: Should the logon fail again, please contact the system
administrator.
4. The phone receives the phone settings. If it fails, the phone will use
the latest settings.
5. If a new software version is available, you will be notified via a
display message.
Vue de la page 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 124 125

Commentaires sur ces manuels

Pas de commentaire